Spray Nozzle Replacement Procedure

Jun 15, 2025

Leave a message

Replacing the spray nozzle is a relatively simple task, but it requires careful operation to ensure correct installation and avoid damage. The following are detailed replacement steps compiled from multiple sources:

1. Preparation work
Tool preparation: Simple tools such as screwdrivers and needles are usually required.
Material preparation: Purchase new nozzles suitable for the vehicle model.
2. Position the nozzle
Find the position of the nozzle, usually located on the front windshield of the car.
3. Disassemble the old nozzle
Gently lift the water nozzle with a screwdriver, and due to its snap design, this process does not require excessive force.
Remove the water nozzle from the small hose connected. Note that the spray nozzle is connected to the hose, and any carelessness may result in damage.
4. Install a new nozzle
Align the newly purchased nozzle with the installation hole and gently press down to ensure a stable installation of the nozzle.
5. Testing and Adjustment
After installation, it is recommended to conduct a water spray test to observe whether the water column is accurately sprayed onto the front windshield.
If there is a deviation in the position of the water column, a fine needle can be inserted into the spray hole for fine adjustment until the desired effect is achieved.
precautions
Please be careful during the entire process to avoid damaging the water spray system 3.
If you lack confidence in your operational ability, it is recommended to seek the assistance of professional technicians.
Spray nozzles are usually recommended to be replaced every 1-2 years, and can be adjusted according to usage.
By following the above steps, you can easily replace the spray nozzle to ensure safe driving and clear vision.

Send Inquiry