Maintenance Method Of Spray Nozzle

Jun 08, 2025

Leave a message

1. Regular cleaning
Cleaning frequency: Depending on the usage environment, the nozzle should be thoroughly cleaned every few months. If the water source or liquid contains more impurities, it needs to be cleaned more frequently.
Cleaning steps:
Remove the nozzle from the device.
Soak the nozzle in a mild and neutral solvent to break down the buildup. Be careful to ensure that the nozzle material is not dissolved by the solvent.
For minor blockages, the nozzle can be completely disassembled and soaked in vinegar, rinsed with clean water overnight, and then reassembled for use.
If it is severely blocked, the nozzle can be completely disassembled and placed in glacial acetic acid, which takes about 2-3 days to remove. It can be washed with clean water before use.
If conditions permit, air compressors or ultrasonic cleaning machines can also be used to clean the nozzle.
2. Correct operating tools
When cleaning the nozzle, avoid using objects that are harder than the surface of the nozzle, such as wire brushes, knives, etc., to avoid damaging the nozzle. Recommend using soft tools such as plastic bristle brushes and/or wooden/plastic scrapers.
3. Inspection and adjustment
Flow inspection: Regularly check whether the reading of the flow meter has increased, or measure the flow rate at a specific pressure within a specified time, and compare it with the data in the manufacturer's catalog to determine whether the nozzle is worn.
Spray shape detection: visually check whether the spray shape is uniform. If the spray becomes uneven and more flow may be seen at the center or edge of the spray, further inspection is required.
Spray coverage: confirm whether the spray coverage of the nozzle is uniform, which can be achieved by observing the actual effect of spray.
Spray pressure and spray volume: monitor the change of spray pressure and flow, use a centrifugal pump to monitor the increase of flow, and use a positive displacement pump to monitor the decrease of pressure.
4. Preventive maintenance
Water quality management: ensure that the water source is clean and free of impurities. If necessary, add sand filtration and RO reverse osmosis equipment to ensure the normal use of spray equipment and nozzles.
Replace accessories: If irreparable damage is found on the nozzle, such as severe blockage or physical damage, a new nozzle should be replaced promptly.
5. Handling of special circumstances
Winter anti freezing measures: In the cold winter, it is necessary to use a liquid with anti freezing function (such as anti freezing glass water) to prevent the nozzle and pipeline from being damaged by freezing

Send Inquiry